AUTHORIZED DELTAC RESELLER
Veryeffectivebreak for your Mosin Nagant
Reduce muzzle rise and recoil
Slingshot Muzzle Brake + M15X1 RH die + Thread alignment tool + Jam nut + Heavy Duty #5 Die Handle
We believe that threading the barrel of the Mosin Nagant is the most effectivemethodto install a muzzle break on your Mosin Nagant because their barrel are not always concentric. See the picture above. There are many breaks on the market that just mount with a bracket secured behind the front sight that end up being shot off with an exiting bullet and are potentially dangerous. Threading your barrel with the use of the enclosed threading tool insure your thread are true and are permanent but ensure reliability and accuracy. Read the article below Titled \"Which muzzle brake should I get, a Bolt-on or a Screw-on?\"
Type: Muzzle BrakeLength: 2.520 inchesCALIBER: 7.62Exit hole .340 inchesThread: M15x1 RH threads.
NOTE:

• Recommended barrel OD sizes for threading using the M15X1RH die is 0.5824 min and 0.5896 max.
• If you shortened your barrel, your barrel OD is now bigger this set up may not fit if you don\'t reduce the OD back to the dimensions 0.5824 min and 0.5896 max.

M15x1.0 RH dieNEW......15mm X 1 Metric Right Hand Thread Die M15 X 1.0mm PitchThread alignment tool:This is a simple TAT (thread alignment tool) for re-threading 7.62 caliber muzzles to accept the above M15 X 1 RH muzzle device.The extended 2\" long stem helps with *Mosin-Nagant barrels which have been counter-bored to renew the muzzle crown..It helps you get the die started level and on-center to prevent costly mistakes.
Material: US made 303 Stainless Steel
#5 Die HandleThis a heavy duty #5 die handle is approx. 10.75in long and accepts1.5in dia (38mm) dies like the M15X1 RH die that we offer on this site.The handle ends are not removable.These are high quality handles made of high tensile steel.
* The Russian arsenal sometimes counter-bore the barrels to prolong their life by cutting out the bad/worn rifling at the muzzle end. If done properly a counter-bore has the potential to improve accuracy. The length of the counter-bore depended on how worn the muzzle end was. You should measure the depth of the counter-bore to make sure that this tool is long enough to reach the caliber bore of the rifle.
MADE IN USA
PKG Content:

• 1 Threaded muzzle break
• 1 M15X1 RH Die
• 1 Thread alignment tool with a 2\" long stem
• #5 die handle
• 1 Jam nut

Skill Level: AdvancedPlease consider your skills before attempting to modify a firearm. Although this is a DIY kit advanced skills are required beyond the written instructions.Modifying a firearm without the proper skills are dangerous to both you and others.

Which muzzle brake should I get, a Bolt-on or a Screw-on?

Related Items:

DELTAC® "Slingshot" Muzzle Brake for Mosin Nagant - Complete Threading Kit

$105.99

---

DELTAC® "Slingshot" Muzzle Brake Threaded in 9/16-24 RH

$49.99

---

DELTAC® "Slingshot" muzzle brake threaded in M14X1 RH for Yugo

$49.99

---

---