2pcs Downstream Oxygen O2 Sensor For 2011 2012 2013 2014 Ford F-150 3.5L 3.7L

Product Description

2013-2015 Ford Explorer 3.5L
2011-2014 Ford F-150 3.5L 3.7L
2013-2015 Ford Flex 3.5L
2011-2012 Ford Fusion 3.0L 2.5L
2011-2014 Ford Mustang 3.7L 5.0L 5.4L
2013-2014 Ford Police Interceptor Sedan 3.5L 3.7L
2013-2014 Ford Police Interceptor Utility 3.7L
2013-2015 Ford Taurus 3.5L
2015 Ford Transit-150 3.7L
2015 Ford Transit-250 3.7L
2015 Ford Transit-350 3.7L
2013-2015 Lincoln MKS 3.7L
2013-2015 Lincoln MKT 3.7L
2011-2012 Lincoln MKZ 2.5L
2013-2015 Lincoln MKZ 3.7L
2011 Mercury Mariner 2.5L 3.0L
2011 Mercury Milan 2.5L 3.0L

The following information is for instructional and guidance reference only. We try and make them as accurate as we can.If Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, check the sensor with a voltmeter as below. If the sensor is good, further diagnosis is required. There\'re many different codes for specific functional failures, which are NOT necessarily relevant to the sensor. Find out what the Code means before leaving any responses.Items that have been installed, altered or contaminated are non-returnable. ONLY a defective sensor after tested by a voltmeter is applied to manufacturer warranty.
20% restocking fee is requiredif buyer bought wrong items due to not paying attention to fitment information and ask for return.
The Price, Quality & Funcitonality of the O2 Sensor is fully covered under our warranty & return policy. However, refund for any labor cost, expense in a dealer shop or damage due to wrong installation is NOT covered.
Q: How do I know the O2 sensor is good or not?（Online Video）A:The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.Use a 10-megaohm digital voltmeter. Hook up the voltmeter\'s red probe to the sensor\'s signal wire and the black probe to engine ground. (Use back probe method,DO NOTpierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes.Please take avideo clipof the voltmeter and contact us if our sensor:Goes above range between 0.1 and 0.9 volt
Remains below 0.5 volts
Stays fixed at a particular voltage
You\'re free to choose replacement or refund if our sensor fails to work, in this case.

• Payment Policy
• Shipping Policy
• Returns Policy
• Contact us

Payment Policy

Shipping Policy

Returns PolicyIf you need return,Please email us before leaving any negative response or opening return request.Contact us

Copyright © 2018 Dianxiaomi

Related Items:

---